Stihl TS 700, TS 800 Service Manual page 50

: Remove the roll pins (arrows)
with a suitable punch.
1
: Remove the switch (1) from the
guide.
Remove the cap when fitting a new
switch.
Note:
Check correct operation before
fitting a new short circuit wire,
b 8.6.1
– Untie the string from the old wire
and tie it to the new wire.
TS 700, TS 800
: Fit straight pins.
– Line up the switch.
– Drive home the roll pins with a
suitable punch until they are
flush.
1
: Pull the short circuit wire (1) in
below the carburetor with the
help of the string.
: Use a deflector when pulling the
wire through between cylinder
and tank housing.
: Place the short circuit wire and
ground wire in the cable guide
(arrow).
The diagram shows the cable
guides on the dismantled tank
housing for clarity.
: Place the short circuit wire in the
cable guides (arrows).
Note:
The wires must be seated securely
in the cable guides. Loose wires
may touch the hot cylinder and be
damaged.
– Reassemble remaining parts in
reverse order.
49