Table of Contents
Advertisement
WHA-ADP2-F8B2-*-**-Z1(-EX1)
Safety
1.8
Mounting and Installation
Prior to mounting, installation, and commissioning of the device you should make yourself
familiar with the device and carefully read the instruction manual.
Do not mount the device at locations where an aggressive atmosphere may be present.
Do not mount a damaged or polluted device.
Only use accessories specified by the manufacturer.
Avoid electrostatic charges which could result in electrostatic discharges while installing,
operating, or maintaining the device.
If the device has already been operated in general electrical installations, the device may
subsequently no longer be installed in electrical installations used in combination with
hazardous areas.
Observe the installation instructions according to IEC/EN 60079-14.
Connection or disconnection of energized non-intrinsically safe circuits is only permitted in the
absence of a potentially explosive atmosphere.
If circuits with type of protection Ex i are operated with non-intrinsically safe circuits, they must
no longer be used as circuits with type of protection Ex i.
The usage of 2400 MHz equipment is bound to local restrictions. Ensure that local restrictions
allow usage of this device before commissioning.
Country
Bulgaria
Italy
Japan
Latvia
Norway
Rumania
1.9
Housing
Ensure that the housing is not damaged, distorted, or corroded.
Ensure that all seals are clean, undamaged, and correctly fitted.
Tighten all screws of the housing/housing cover with the appropriate torque.
For cable glands only use incoming cable diameters of the appropriate size.
Tighten all cable glands with the appropriate torque.
Close all unused cable glands with the appropriate sealing plugs.
Close all unused enclosure holes with the appropriate stopping plugs.
1.10
Operation, Maintenance, Repair
Do not repair, modify, or manipulate the device.
If there is a defect, always replace the device with an original device.
When the device is in operation, maintain at all times a distance of at least 20 cm to the device
antenna. This also applies to any other person in the vicinity of the device.
8
Guideline
General authorization required for outdoor use and public service.
If used outside of own premises, general authorization is required.
The device is granted pursuant to the Japanese Radio Law and the Japanese
Telecommunications Business Law.
The device must not be modified (otherwise the granted designation number will
become invalid).
The outdoor usage of the 2.4 GHz band requires an authorization from the
Electronic Communications Office.
May be restricted in the geographical area within a radius of 20 km from the
center of Ny-Alesund.
Use on a secondary basis. Individual license required.
Advertisement
Table of Contents
