Table of Contents
Advertisement
WHA-ADP2-F8B2-*-**-Z1(-EX1)
Commissioning
2. Connect the Ex ia certified HART modem to terminals 7 + 8. You can also use terminals
5 + 6 as these terminals are connected internally.
If the HART modem has an internal communication resistor, this should be switched off at
the first attempt to communicate. If communication fails, a resistor may be required. See
chapter 8
3. Switch on your PC/Laptop.
4. Plug the HART modem into the USB/RS232 port.
If using the USB port, your PC/Laptop should recognize the HART modem automatically.
If using the RS232 port, proceed with the next step.
5. To find out to which COM port the HART modem is connected, open the Windows
manager. For example, if using Windows
System > Hardware > Device Manager, or if using Windows
Control Panel > System > Device Manager.
Under Ports (COM & LPT) you see the HART modem and the COM port assigned to it.
You will need the COM port number later on.
4.4
DTM Software
4.4.1
Downloading the Required Software
Required software:
Microsoft
PACTware
WirelessHART DTM
The DTM collection including WirelessHART device DTMs and Ethernet communication
DTM.
HART CommDTM
The HART CommDTM has to be installed separately. It is required for wired
communication via HART modem. The HART CommDTM supports both FSK (i.e. HART
modem) and RS-485 interfaces.
Note!
If one of the software components is already installed on your system, the installation may be
omitted.
Where to download the required software?
1. Open your internet browser and visit www.pepperl-fuchs.com.
2. Click Products.
3. Click Software.
4. Download the software components Microsoft
WirelessHART DTM and HART CommDTM. You might need to scroll down the page to
find the required component.
5. Unzip the downloaded files and store the data to your local hard drive.
4.4.2
Installing the DTM Software Components
Your computer must meet the following requirements in order to run PACTware
device DTM:
Operating system: Windows
Windows
Software: Microsoft
®
.NET Framework
TM
Framework
®
2000 Service Pack 4, Windows
®
Vista
®
.NET Framework Release 1.1 Service Pack 1
®
XP, click Start > Settings > Control Panel >
®
7, click Windows Icon >
®
.NET Framework, PACTware
®
XP Service Pack 1/2/3 or
®
device
TM
,
TM
and the
31
Advertisement
Table of Contents
