WHA-ADP2-F8B2-*-**-Z1(-EX1)
Configuration
5.6
Device Variable Mapping
The adapter can output the value and status of several variables, but a maximum of only four
variables can be published on the network. The device variable mapping is used to configure
these variables.
Figure 5.7
The variables that can be set as SV, TV and QV are as follows:
Temperature
Temperature min
Temperature max
Battery voltage
Consumer energy
RSL of best neighbour (RSL = Radio Signal Level)
RSL of second best neighbour
Battery voltage with load
Battery voltage without load during battery test
Normalized Consumer Energy
Estimated Lifetime
46
Device variable mapping