Operation; Controls And Indicators; Leds - Pepperl+Fuchs WHA-ADP2-F8B2 Z1 Series Manual

WHA-ADP2-F8B2-*-**-Z1(-EX1)

Operation

6 Operation
6.1

Controls and Indicators

The operating and display elements of the WirelessHART Adapter are located inside of the
housing.
They are used during the commissioning of the device and for local diagnosis.
Figure 6.1
1 Red LED
2 Green LED
3 Yellow LED
4 Button
6.1.1

LEDs

Note!
To save battery power all LEDs are off during normal operation, even if the device is
communicating or joining the network. The LEDs only light up after start up or while pressing
the buttons.
When the pushbutton is pressed shortly (0.2 s ... 5 s), the three LEDs indicate the status of the
adapter. See chapter 6.1.2
LED Indicators
Number of LEDs
Indications of green LED (battery status)
LED on
LED flashes at 1 Hz
see Figure 2.2 on page 12
1 2 3
Controls and indicators
3 (green, yellow, red)
Normal: at least one month of battery life is left.
Warning: less than one month of battery life is left.
4
59