Mounting To A Wall - Pepperl+Fuchs WHA-ADP2-F8B2 Z1 Series Manual

WHA-ADP2-F8B2-*-**-Z1(-EX1)
Installation
1 Counternut
2 Cable entry
3 Connection adapter
Tip
Loosening the counternut allows the adapter to be screwed into position without the need to
turn the adapter housing.
Mounting the adapter directly on a field device
1. Remove the blind plug from the cable entry at the side of the adapter.
2. Push a Viton gasket on either side of the connection adapter supplied with the adapter.
3. Using a spanner, screw the connection adapter tightly into the cable entry of the field drive
(torque 5 Nm + 1 Nm).
4. Loosen the counternut on the adapter.
5. Insert the other end of the connection adapter into the cable entry of the adapter and screw
tight (torque 5 Nm + 1 Nm).
6. Align the adapter so that the antenna is vertical.
7. With the cable entry nut held with a spanner, tighten the counternut (torque 7 Nm).
3.2.2

Mounting to a Wall

Figure 3.7
1 Mounting bracket
2 Blind plug
As an addition to the tools already listed (see chapter 3.2.1), an M4 Allen key/bit is required to
tighten the mounting bracket screws.
Mounting to a wall with mounting bracket
1
2
19