Measured Value - Pepperl+Fuchs WHA-ADP2-F8B2 Z1 Series Manual

WHA-ADP2-F8B2-*-**-Z1(-EX1)
Operation
Duration
5 s ... 10 s
10 s ... 15 s Start
> 15 s
Inserting the battery while the button is already pressed
The following functions are available when connecting the battery while the button is already
pressed. The duration starts from the moment the battery is connected (red LED lights).
< 10 s
10 s ... 15 s Configuration
20 s ... 25 s Firmware and
> 25 s
6.2

Measured Value

The Measured Value function displays the current value and status of the variables selected in
the Device Variable Mapping dialog.
The following information is displayed:
Primary Variable
Secondary Variable
Tertiary Variable
Quaternary Variable
Loop-Current
Function Procedure
Join wireless Keep button pressed for 5 seconds.
network
After 5 sesconds the yellow LED starts flashing at 3 Hz.
Release button.
The yellow LED extinguishes.
The adapter starts joining.
Keep button pressed for 10 seconds. After 5 seconds the
configuration
yellow LED starts flashing at 3 Hz. After 10 seconds the red
mode
LED starts flashing at 3 Hz.
The adapter enters configuration mode.
Release button.
Configuration mode is retained until there was no HART
communication for 300 seconds (configurable) or until
pushbutton is pressed again for 10 seconds ... 15 seconds.
The red LED extinguishes.
No function
No function The red LED lights until the pushbutton is released.
Keep button pressed for 10 seconds. The red LED lights
reset to
during this time.
default
After 10 seconds the red LED starts flashing at 2.5 Hz.
settings
Release button to start the reset.
Keep button pressed for 20 seconds. During this time the red
configuration
LED lights for 10 seconds. Then the red LED starts flashing at
reset to
2.5 Hz. After this, the red LED lights again.
default
settings
After 20 seconds the red LED starts flashing at 1.25 Hz.
Release button to start the reset.
No function The red LED remains lit until the pushbutton is released
61