Mounting To A Pipe - Pepperl+Fuchs WHA-ADP2-F8B2 Z1 Series Manual

WHA-ADP2-F8B2-*-**-Z1(-EX1)
Installation
Mounting to a wall with mounting bracket
1. Mount the mounting bracket at a suitable position on the wall.
2. Unscrew and remove the counternut.
3. Thread the cable entry through the hole in the mounting bracket such that the antenna is is
on the side farthest away from the wall.
4. Remount the counternut and screw until the adapter is loosely held.
5. Align the adapter so that the antenna is vertical.
6. With the cable entry nut held with a spanner, tighten the counternut (torque 7 Nm).
3.2.3

Mounting to a Pipe

Note!
The maximum pipe diameter for pipe mounting is 70 mm.
Figure 3.8
1 Pipe/post, ∅ max. 70 mm
2 Pipe mounting bracket
3 Mounting bracket
Mounting to a Pipe
1. Mount the pipe mounting bracket at a suitable position on the pipe and screw tight (torque
min. 5 Nm).
2. Using the four screws supplied, screw the mounting bracket to the pipe mounting bracket
(torque 4 Nm + 1 Nm).
3. Unscrew and remove the counternut.
20
Mounting to a pipe
1
2
3