Table of Contents
Advertisement
WHA-ADP-*
Safety
1.0.8
Mounting and Installation
Prior to mounting, installation, and commissioning of the device you should make yourself
familiar with the device and carefully read the instruction manual.
The device must not be installed at locations where corrosive vapors may be present.
The installation instructions in accordance with IEC/EN 60079-14 must be observed.
Care must be taken when operating the installed device because of electrostatic discharge
hazard.
Local restrictions for 2400 MHz equipment
The usage of 2400 MHz equipment is bound to local restrictions. Ensure that restrictions
allow usage of this product before commisioning.
Coexistence of wireless technologies
WirelessHART networks use the frequency spectrum between 2400 ... 2483.5 MHz
according to IEEE 802.15.4. Various other wireless technologies also use this frequency
spectrum, for example WLAN and Bluetooth. These different wireless technologies may
affect each other.
Wireless technologies used in an industrial environment must be able to coexist without
disrupting each other. Take appropriate measures to ensure the operation of all wireless
systems.
The enclosure should only be opened for installation and maintenance purposes.
To ensure the IP degree of protection:
•
all seals must be undamaged and have been correctly fitted
•
all screws of the housing / housing cover must have been tightened with the appropriate
torque
•
only cable of the appropriate size must be used in the cable glands
•
all cable glands must have been tightened with the appropriate torque
•
all empty cable glands must have been sealed with sealing plugs
1.0.9
Operation
When the device is in operation, a distance of at least 20 cm must be maintained at all
times between the device antenna and the body of the user or any other person within the
vicinity of the measuring point irrespective of application or use.
8
Advertisement
Table of Contents
