Table of Contents
Advertisement
WHA-ADP2-F8B2-*-**-Z1(-EX1)
Configuration
Linearization
Parameter
X: mA (1 ... 32)
Y: unit (1 ... 32)
Read
Write
5.7.2
Burst Mode Parameters
Burst mode is a special communication mode in which a HART slave device sends responses
to a particular HART command on a predetermined, periodic schedule without being polled by
the master. Normally, a HART slave device only responds when being polled by the master.
When burst mode is used, a HART slave device can publish data (for example process values)
independently in regular time intervals. Data can be sent as scheduled, or only if the value has
changed by a significant amount or has not been updated within a default reporting time.
Up to 10 different burst modes can be set for the adapter or connected HART devices.
Figure 5.10
Note!
Battery lifetime
The more frequently burst messages are sent the more battery power is consumed, thus
reducing battery lifetime.
50
Description
Input value X1 ... X32 for linearization (mA)
Output value Y1 ... Y32 for linearization (engineering units)
Press to upload values from the device into the DTM.
Happens automatically when the Linearization leaf is
opened.
Press to download the table from the DTM to the device.
Burst Mode Parameters
Default
4, 20
4, 20
–
–
Advertisement
Table of Contents
