WHA-ADP-*
Installation
3.2.3
Mounting to a Pipe
Note!
The maximum pipe diameter for pipe mounting is 70 mm.
Figure 3.6: Mounting to a pipe
Pipe/post, max. 70 mm
1
2
Pipe mounting bracket
3
Mounting bracket
Mounting to a Pipe
1. Mount the pipe mounting bracket at a suitable position on the pipe and screw tight
(torque min. 5 Nm).
2. Using the four screws supplied, screw the mounting bracket to the pipe mounting
bracket (torque 4 Nm + 1 Nm).
3. Unscrew and remove the counternut.
4. Thread the cable entry through the hole in the mounting bracket such that the antenna
is is on the side farthest away from the wall.
5. Remount the counternut and screw until the adapter is loosely held.
6. Align the adapter so that the antenna is vertical.
7. With the cable entry nut held with a spanner, tighten the counternut (torque 7 Nm).
20
1
2
3