Mounting To A Wall - Pepperl+Fuchs WHA-ADP Series Manual

WHA-ADP-*
Installation
3.2.2

Mounting to a Wall

Figure 3.5: Mounting to a wall with mounting bracket
1 Mounting bracket
2 Blind plug
As an addition to the tools already listed (see chapter 3.2.1), an M4 Allen key/bit is required
to tighten the mounting bracket screws.
Mounting to a wall with mounting bracket
1. Mount the mounting bracket at a suitable position on the wall.
2. Unscrew and remove the counternut.
3. Thread the cable entry through the hole in the mounting bracket such that the antenna
is is on the side farthest away from the wall.
4. Remount the counternut and screw until the adapter is loosely held.
5. Align the adapter so that the antenna is vertical.
6. With the cable entry nut held with a spanner, tighten the counternut (torque 7 Nm).
1
2
19