Extron electronics IN1804 Series User Manual page 87

Command
Information Requests (continued)
Query part number
View internal temperature
Set verbose mode
View verbose mode
KEY:
X1@
= Internal temperature
X3$
= Verbose mode (see the
command description
more information)
X3^
= Part number
IP Control Port Commands
IP Setup
NOTES:
• Changes made to any TCP/IP settings do not take effect until the reboot network command (
• The following IP address setup commands that are followed by
issue them without Administrator status result in an
Set DHCP mode
24
View DHCP mode
Set IP address
24
Read IP address
Set subnet mask
24
View subnet mask
Set gateway IP address
24
View gateway IP address
KEY:
X1)
= On or off, enable or disable
X8&
= IP address
X8*
= Gateway address
X8(
= Subnet mask
X9)
= Hardware (MAC) address
ASCII Command Response
(Host to Switcher) (Switcher to Host)
N X3^]
Verbose modes 2 and 3:
X3^]
Pno
E 20STAT }
X1@]
Verbose modes 2 and 3:
20Stat• X1@ ]
EX3$ CV } X3$]
Vrb
E CV } X3$]
In degrees Celsius. Response is two digits, padded with a zero.
0
verbose mode = None (default for LAN connection)
1
on page 55 for
= Verbose mode (default for RS-232 and USB connection)
2
= Tagged responses to queries
3
= Verbose mode and tagged responses
IN1804 (standard) —
IN1804 DI —
IN1804 DO —
IN1804 DI/DO —
E24
E X1) DH } Idh X1)]
E DH }
X1)]
E X8& CI } Ipi • X8&]
E CI }
X8&]
E X8( CS } Ips • X8(]
E CS }
X8(]
E X8* CG } Ipg • X8*]
E CG }
X8*]
0
= DHCP disabled (default),
Format
Leading zeros in each of the four octets are optional in setting values,
and are suppressed in returned values.
nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
00-05-A6-xx-xx-xx
IN1804 Seamless Scaling Switchers • SIS Configuration and Control
Additional Description
View unit part number
View unit internal temperature
degrees Celsius.
Set the verbose mode to
without tagged responses.
View the current verbose mode.
60-1699-01
or
60-1699-02 60-1699-12
or
60-1699-03 60-1699-13
or
60-1699-14
24 require Administrator permission to enter. Attempts to
(privilege violation) error message.
Enable or disable DHCP.
View the DHCP mode setting.
Set the IP address to
View the current IP address.
Set the subnet mask to
View the subnet mask setting.
Set the gateway IP address to
View the gateway IP address setting.
1
= DHCP enabled
nnn.nnn.nnn.nnn 192.168.254.254
(
0.0.0.0
( = default)
255.255.255.0
(
X3^
for the model.
X1@
in
X3$
, with or
60-1699-11
E 2BOOT }
) is issued.
X8&
.
X8(
.
X8*
.
= default)
= default)
79