Extron electronics IN1804 Series User Manual page 89

Command
IP Control Port Commands (continued)
Passwords
NOTE: The initial passwords set at the factory are the serial number of the unit. However, if the unit is reset (via the
SIS command or the rear panel
Set administrator password
View administrator password
Reset (clear) administrator
password
Set user password
View user password
Reset (clear) user password
KEY:
X9!
= Password
If there is a valid password, the response is ****
NOTE:
ASCII Command Response
(Host to Switcher) (Switcher to Host)
Reset
button), this password reverts to no password.
E X9! CA } Ipa• X9!]
E CA }
****
In verbose modes 2 and 3:
Ipa
•****
Ipa• ]
E •CA }
E X9! CU } Ipu• X9!]
E CU }
****
In verbose modes 2 and 3:
Ipu
•****
E •CU } Ipu• ]
• Length is
• All human-readable characters are permitted except
• The password cannot be a single space.
• Passwords are case-sensitive.
• A user password cannot be assigned if no administrative password
exists. An
• If the admin password is cleared, the user password is cleared also.
IN1804 Seamless Scaling Switchers • SIS Configuration and Control
Additional Description
Set the administrator password to
] or ]
View the administrator password.
Ipa ]
]
or
Reset or clear the administrator
password.
Set the user password.
] or ] View the user password. If there is a
valid password, the response is ****
If there is no password, the response is
] Ipu ]
or
]
.
Reset or clear the user password.
1 128
- characters.
E14
error code is returned.
]
. if there is no password, the response is
ZQQQ
X9!
.
]
.
|
.
]
.
81