Extron electronics IN1804 Series User Manual page 69

Command
Input Configuration (continued)
Auto-Image
Execute
Execute and fill
Execute and follow
HDCP Authorize
DP Input 1 is fixed with HDCP Authorize enabled and cannot be configured.
NOTE:
HDCP authorized
Query HDCP authorized
status
Input Aspect Ratio (per input)
Set for fill
Set to follow
View aspect setting
Active Pixels and Lines
View active pixels
View active lines
3:2, 2:2, and 24:1 Film Mode Detection
Auto
Off
View film mode setting
KEY:
X!
= Input selection
X*
= Active pixels
X(
= Active lines
X1)
= On or Off status
X3(
= Aspect ratio setting
ASCII Command Response
(Host to Switcher) (Switcher to Host)
1*0A Img1*0 ]
1*1A Img1*1 ]
1*2A Img1*2 ]
E E X! * X1) HDCP } HdcpE X! * X1)]
E E X! HDCP } X1)]
E X! *1ASPR } Aspr X! *1 ]
E X! *2ASPR } Aspr X! *2 ]
E X! ASPR } X3(]
E X! APIX }
X*]
Verbose modes 2 and 3:
Apix X! * X*]
E X! ALIN } X(]
Verbose modes 2 and 3:
Alin X! * X(]
E X! *1FILM } Film X! *1 ]
E X! *0FILM } Film X! *0 ]
E X! FILM }
X1)]
1
2
3
4
Response is four digits, padded with zeros.
Response is four digits, padded with zeros.
0
1
1
2
IN1804 Seamless Scaling Switchers • SIS Configuration and Control
Additional Description
Execute an Auto-Image for the current
input (follows the current aspect ratio).
Execute an Auto-Image and fill the
output raster.
Execute an Auto-Image and maintain
the aspect ratio of the current input.
Configure HDCP Authorize for input
View HDCP Authorized setting for input
X!
.
Set input
output raster.
Set input
native aspect ratio.
View current aspect ratio setting
X!
input
View active pixels
View active lines
Enable automatic film mode detection
for input
Disable film mode detection for input
View the film mode setting for input
= DisplayPort input 1 (all models)
= HDMI or DVI input 2 (all models)
= HDMI or DVI input 3 (all models)
= HDMI or DVI (standard and DO models)
TP (IN1804 DI and DI/DO)
= Off or disabled
= On or enabled (default)
= Fill — Each input rate fills the entire output raster (default)
= Follow — Each input rate is displayed with its native aspect
ratio.
X!
X!
to always fill the entire
X!
to maintain its current
X3(
for
.
X* X!
on input .
X( X!
on input .
X!
(default).
X!
X!
.
.
.
61