Extron electronics IN1804 Series User Manual page 65

X5@ = Audio input format
Format
Selection
0 = None (input muted) —Configures input EDID with no audio support. All audio
outputs are muted.
1 = Analog input — Configures input EDID with no audio support. Analog audio
from the 5-pole captive screw input is passed to the 5-pole captive screw
analog output and embedded into the HDMI output.
LPCM-2Ch — Configures input EDID for LPCM-2Ch support. Passes all digital
2 =
audio input signals to the HDMI outputs. If LPCM-2Ch audio is present it is also
de-embedded to the 5-pole captive screw analog output.
Multi-Ch — Configures input EDID for Multi-Ch support. Passes all digital
3 =
audio input signals to the HDMI outputs. If LPCM-2Ch audio is present it is also
de-embedded to the 5-pole captive screw analog output.
4 = LPCM-2Ch Auto (default) — Configures input EDID for LPCM-2Ch support.
Passes all digital audio input signals to the HDMI outputs. If LPCM-2Ch audio
is present it is also de-embedded to the analog 5-pole captive screw output.
If no embedded audio is present on the input the IN1804 passes analog audio
from the 5-pole captive screw input.
Multi-Ch Auto — Configures input EDID for Multi-Ch support. Passes all digital
5 =
audio input signals to the HDMI outputs. If LPCM-2Ch audio is present it is also
de-embedded to the analog 5-pole captive screw output.
If no embedded audio is present on the input, the IN1804 passes analog audio
from the 5-pole captive screw input.
*
On the IN1804 DI and DI/DO, when Input 4 is set to DTP mode, the switcher uses analog
audio from the remote DTP transmitter instead of analog audio from the rear panel of the
IN1804. Analog and Auto formats are not allowed on input 4 of the IN1804 DI and DI/DO
when they are set to XTP mode.
X5$ = Analog audio input gain
NOTE: On IN1804 DI and DI/DO, analog gain adjustment is not available on TP Input 4
0 dB
(fixed at ).
X5% = Video signal status
X5& = Remote port number
X5* = Baud rate
X5( = Parity
X6) = Data bits
X6! = Stop bits
IN1804 Seamless Scaling Switchers • SIS Configuration and Control
Details
-18 +24
through dB
0
= default
Response is two digits.
0
= Video, TMDS, or DP signal not detected
1
= Video, TMDS, or DP signal detected
1
= Remote port (3-pole captive screw)
4
= Universal asynchronous receiver-transmitter (UART)
on DTP input 4 (IN1804 DI and DI/DO only)
9
= UART on DTP/HDBT output 1A (IN1804 DO and
IN1804 DI/DO only)
300 600 1200 1800 2400
, , , ,
9600 14400 19200
(default), ,
115200
Odd Even N M
, , one (default), ark,
Only the first letter is required.
7 8
or (default)
1 2
(default) or
*
3600 4800, 7200
, , ,
28800 38400 57600
, , , ,
S
pace
57