Communication Submenu - Extron electronics IN1804 Series User Manual

However, for 4K @ 60 Hz rate only, either the input resolution or the output resolution
can be at 4K @ 60, but not both. For example, the input can be 4K @ 60 Hz with
a 4K @ 30 Hz output and vice versa, but both the input and output cannot be
4K @ 60 Hz.
NOTE: This special condition applies only to the currently selected input. For
example, if the current input is 4K @ 30 Hz and the output is 4K @ 60 Hz, and you
switch to a 4K @ 60 source, the OSD menu and logo remain visible. However, if
you switch back to the 4K @ 30 input, the OSD and logo are disabled.
Factory Reset — Resets the unit to its factory default values (removing any
•
user-specified values) while retaining all TCP/IP settings.
To reset using the OSD menu, press and hold the Enter button until Factory Reset is
displayed (approximately 5 seconds). The message remains for approximately 1 minute
after the reset is complete to allow time for the display device to sync with the IN1804
output.
NOTE: The equivalent SIS command is E ZXXX } . This command does not affect
the current password, including the initial factory-set serial number.
For other reset methods, see

Communication Submenu

Figure 30.
The Communication submenu enables you to view the serial port baud rate and the unit
media access code (MAC) address, and to configure the IP address, subnet mask, and
gateway address, and DHCP mode.
• Serial Port Baud Rate — Displays the baud rate for the serial RS-232 port (view only).
MAC Address — Displays the MAC address of the device (view only).
•
Reset Modes
Communication Submenu
IN1804 Seamless Scaling Switchers • Operation
on page 42.
40