Csmp-Set Sms Text Mode Parameters; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
(the exact value is up to ME implementation), then ME shall close the link and TA
switches <n> automatically back to 0.
2: Enable (if the time between the response of the latest message send command and
the next send command exceeds 1–5 seconds (the exact value is up to ME
implementation), ME shall close the link but TA shall not switch automatically back to
<n>=0).
6.18 +CSMP–Set SMS TEXT Mode Parameters

6.18.1 Command Syntax

Command
+CSMP=[<fo>],[[<vp>
],[[<pid>],[<dcs>]]]
+CSMP?
+CSMP=?

6.18.2 Description

The SET command is used to set external parameters when sending or storing SMS,
such as period of validity, etc. (It is effective only when the current mode is TEXT
mode.)
The READ command returns the supported parameters.
The TEST command returns OK.

6.18.3 Defined Values

<fo>: first Octet
<vp>: integer value, range from 0 to 255.
<pid>: integer value, protocol indication, 0 is default.
<dcs>: integer value, data coding scheme, 0 is default.
Note:
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CSMP:
[<fo>],[<vp>],<pid>,<dcs><CR><LF><CR><LF>OK<CR><
LF>
<CR><LF>OK<CR><LF>
In TEXT mode, when choose GSM 7 bit coding mode, only support GSM 7 bit basic characters,
not support GSM 7 bit extended characters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
101