Cced-Query Cell Environment; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
1: –111 dBm
2–30: –109 to –53 dBm
31: Equals to or higher than –51 dBm
99: Unknown or unmeasurable.
<ber> (bit error rate,in percent):
0–7: As RXQUAL values in the table in TS 45.008 [20] subclause 8.2.4
99: Not known or not detectable
14.5 +CCED–Query Cell Environment

14.5.1 Command Syntax

Command
+CCED=<mode>[,<requeste
d dump>]
+CCED?
+CCED=?

14.5.2 Description

This command can be used by the application to retrieve the parameters of the main
cell and of up to six neighbouring cells.
This command is only able to query the information of GSM. It will return OK for
WCDMA.

14.5.3 Defined Values

<mode>: return mode
0: Only return once.
<requested dump>: which cell to show.
1: Main cell
<mcc>: mobile country code
<mnc>: mobile network code
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>+CCED:[<mcc>],[<mnc>],[<lac>],[<ci>],[
<bsic>],[<bcch_freq>],[<rxlvel>]<[<rxlevel_full>],[<r
xlevel_sub>],[<rxqual>],[<rxqual_full>],[<rxqual_su
b>],[<idle_ts>]><CR><LF>
<CR><LF>OK<CR><LF>
In case of error:
<CR><LF>ERROR<CR><LF>
<CR><LF>OK<CR><LF>
<CR><LF>OK<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Network Service Commands
188