Description; Defined Values; S5-Set Backspace Character; Command Syntax - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification

3.3.2 Description

This command is used to set the response format character S4. S4 saves the
response format character in the form of ASCII code value. This character is sent by
MS, and serves as a part of the header, tail and end mark of the "result code" and
"information response".
If the S4 character is changed in a command line, the "result code" of this command
line will use the new S4 character immediately, rather than waiting until the next
command line.

3.3.3 Defined Values

<value>:
000–127: The S4 character is set in the form of ASCII code value.
Default value is 010.
Note:
3.4 S5–Set Backspace Character

3.4.1 Command Syntax

Command
S5=<value>
S5?
3.4.2 Description
This command is used to set the backspace character S5. S5 saves the backspace
character in the form of ASCII code value. This character is sent by TE, and means to
delete the previous character. It is identified by MS.
3.4.3 Defined Values
<value>:
000–127: The S5 character is set in the form of ASCII code value.
Default value is 008.
Issue 04 (2013-01-28)
If you want to set <value>=1, you can input "ATS4=001", or "ATS4=1", the result is same.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF><value><CR><LF>
<CR><LF>OK<CR><LF>
Configuration Commands
28