HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
11.10 ^AUDIOCFG–Set Tone Volume Level
11.10.1 Command Syntax
Command
^AUDIOCFG=<tone_ty
pe>,<tone_volume>
^AUDIOCFG?
^AUDIOCFG=?
11.10.2 Description
This command is used to set the volume of specific type tone.
The TEST command returns supported values as compound value.
11.10.3 Defined Values
<tone_type>: 0–2. Integer type value with manufacturer specific range.
0: Incoming call ring
1: Local dtmf tone
2: Busy tone
<tone_volume>:
Incoming call ring:
0–1: Integer type value with manufacturer specific range. 0 means turning off the
Incoming call ring function. Default value is 1, means turning on the function.
Resetting the module will not affect the value. Module updating will reset the value to
default value.
Local dtmf tone:
0–7: Integer type value with manufacturer specific range(smallest value represents
the lowest sound level). 0 means mute. Default value is 2. Resetting the module will
not affect the value. Module updating will reset the value to default value.
Busy tone:
0–1: Integer type value with manufacturer specific range. 0 means turning off the Busy
tone function. Default value is 1, means turning on the function. Resetting the module
will not affect the value. Module updating will reset the value to default value.
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>ERROR<CR><LF>
<CR><LF>^AUDIOCFG: <tone_type>,<tone_volume>
[<CR><LF>^AUDIOCFG: <tone_type1>,<tone_volume1>
[<CR><LF>^AUDIOCFG: <tone_type2>,<tone_volume2>
...]]
<CR><LF><CR><LF>OK<CR><LF>
<CR><LF>^AUDIOCFG: (list of supported
<tone_type>s)<CR><LF><CR><LF>OK<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Audio Commands
162