Cgact-Activate Or Deactivate Pdp Context; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
0: No
1: Yes
2: No detect
Other values are reserved.
<Transfer delay>: a numeric parameter (0, 1, 2,...) that indicates the targeted time
between request to transfer an SDU at one SAP to its delivery at the other SAP, in
milliseconds
<Traffic handling priority>: a numeric parameter (1, 2, 3 ...) that specifies the relative
importance for handling of all SDUs belonging to the UMTS bearer compared to the
SDUs of other bearers.
If a value is omitted for a particular class then the value is considered to be
unspecified.
8.5 +CGACT–Activate or Deactivate PDP Context

8.5.1 Command Syntax

Command
+CGACT=<state>[,<cid>
[,<cid>[,...]]]
+CGACT?
+CGACT=?

8.5.2 Description

This command is used to activate or deactivate the PDP contexts indicated by <cid>s.
If no <cid>s are specified the activation/deactivation form of the command, activate or
deactivate all defined PDP contexts.

8.5.3 Defined Values

<state>: integer value, indicates the active state of the PDP context.
0: Deactivated
1: Activated
<cid>: the identifier of PDP context (referred to +CGDCONT)
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
In case of error:
<CR><LF>ERROR<CR><LF> or
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CGACT: <cid>,<state>
[<CR><LF>+CGACT:
<cid>,<state>[...]]<CR><LF><CR><LF>OK<CR><LF>
<CR><LF>+CGACT: (list of supported
<state>s)<CR><LF><CR><LF>OK<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GPRS Service Commands
125