Cend-Indicate Call End; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
<call_type>: the type of the current call.
0: Voice call
9.17 ^CEND–Indicate Call End

9.17.1 Command Syntax

Command

9.17.2 Description

This command indicates that the call is hung up.

9.17.3 Defined Values

<call_id>: the ID of the current call. The value ranges from 1 to 9.
<duration>: call duration in seconds
<end_status>: call end cause
CM_CALL_END_OFFLINE=0,
CM_CALL_END_NO_SRV=21,
CM_CALL_END_FADE=22,
CM_CALL_END_INTERCEPT=23,
CM_CALL_END_REORDER=24,
call.
CM_CALL_END_REL_NORMAL=25,
CM_CALL_END_REL_SO_REJ=26,
service.
CM_CALL_END_INCOM_CALL=27,
CM_CALL_END_ALERT_STOP=28,
during the call.
CM_CALL_END_CLIENT_END=29,
client.
CM_CALL_END_ACTIVATION=30,
OTASP call.
CM_CALL_END_MC_ABORT=31,
stops the call.
CM_CALL_END_RUIM_NOT_PRESENT=34,
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>^CEND:<call_id>,<duration>,<end_status>[,
<cc_cause>]<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Call Control Commands
The board is in offline mode.
The board is out of service.
The call is ended normally.
The call is interrupted by the BS.
A BS record is received during the
The BS releases the call.
The BS rejects the current SO
A call from the BS is received.
A ringing stop signaling is received
The call is ended normally at the
The activation is ended during the
The MC stops initiating the call or
The RUIM does not exist.
141