Curc-Control Unsolicited Report; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
3.19 ^CURC–Control Unsolicited Report

3.19.1 Command Syntax

Command
^CURC=<mode>
^CURC?
^CURC=?

3.19.2 Description

The SET command is used to set mode value to open or close unsolicited reports.
The unsolicited reports it can control are listed below: ^RSSI, ^MODE, ^SRVST,
^MODE, ^SMMEMFULL. The unsolicited reports are closed if the mode value is set to
0 and the unsolicited reports are open if the mode value is set to 1. The default value
of mode is set to 0. So, "^CURC=1" should be executed if all the unsolicited reports
need to be open.
The READ command returns the current mode value.
The TEST command returns the value range it supports.
Unsolicited report is disabled after reset. In sleep mode, unsolicited reports will be
ignored, since the ports are closed.

3.19.3 Defined Values

<mode>:
0: The unsolicited reports closed (default value).
1: The unsolicited reports open.
3.20 ^MSO–Power Off Module
3.20.1 Command Syntax
Command
^MSO
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>^CURC:<mode><CR><LF>
<CR><LF>OK<CR><LF>
<CR><LF>^CURC:(list of supported <mode>s)<CR><LF>
<CR><LF>OK<CR><LF>
Possible response(s)
<CR><LF>OK<CR><LF>
In case of error:
<CR><LF>ERROR<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Commands
42