Examples - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
Table 6-1 SMS-DELIVER result code and acknowledgement summary
<mt>
1
2
3
Notes:
<bm>: for use of setting the cell broadcast information. It is reserved, not supported
currently. The default value is 0.
<ds>: for use of setting the message acknowledgement.
0: Do not send message acknowledgement to the TE (default value)
1: Do not store message acknowledgement in MS, route message acknowledgement
directly to TE.
When mode = 0 or 2, <ds> can‟t be set to 1.
+CDS: <length><CR><LF><pdu>
2: If the message acknowledgement is stored in the MS, a storage position notification
will be sent to the TE via "+CDSI".
+CDSI: <mem>,<index>
Note:
<bfr>: for use of setting buffer processing after transition from <mode>=0 to
<mode>=1, 2. It is reserved, not supported currently.
0: If <mode>=1 or 2, the buffered unsolicited result codes will be sent to the TE at a
time (default value).
1: If <mode> = 1 or 2, the buffered unsolicited result codes will be emptied.

6.3.4 Examples

AT+CNMI=1,1,0,1,0.
Issue 04 (2013-01-28)
no class class 0 or message
or class 1 waiting indication
group (discard)
+CMTI [+CMTI]
+CMT & +CMT [& +CNMA]
+CNMA
+CMTI [+CMTI]
 The class of message is given by the TP-DCS domain of the message. For details, see the
DCS parameter description of the "+CMGS" command.
+CMT & +CNMA means requiring TE to send a confirmation (+CNMA).

Because "SR" is not supported, +CDSI can be sent out, but new message state report will be
lost.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
class 2 or message
class 3
waiting
indication group
(store)
+CMTI +CMTI
+CMTI +CMT & +CNMA
+CMTI +CMT & +CNMA
69