HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
3.7.2 Description
This command sets whether or not the TA transmits result code to the TE.
3.7.3 Defined Values
<value>:
0: DCE transmits result code (default value).
1: Result codes are suppressed and not transmitted.
Note:
3.8 Z–Resume User Settings
3.8.1 Command Syntax
Command
Z
3.8.2 Description
The SET command resumes the user settings which are stored by AT&W command.
The commands and parameters which can be resumed are as follows:
Table 3-2 The commands and parameters which can be resumed
Command
E
V
Q
&C
&D
&S
+IFC
S0
Issue 04 (2013-01-28)
ATQ will set value to 0.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible response(s)
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>ERROR<CR><LF>
Parameter
<value>
<value>
<value>
<value>
<value>
<value>
<DCE_by_DTE>,<DTE_by_DCE>
<value>
Configuration Commands
31