Figure 3-14: Afl3-W10A-Al Rfid Reader Installation - IEI Technology AFL3-W10A-AL User Manual

AFL3-W10A/12A/W15A-AL Panel PC
Step 6: Route the cable as shown in the following diagrams and connect the brown
connector of the RFID cable to the RFID connector (RFID_USB) on the system
motherboard.
Step 7: Peel off the backing from the rubber foam and stick it to the system as shown in
the following diagrams.
Step 8:
Peel off the backing from the antenna and attach the antenna to the system as
shown in the following diagrams.

Figure 3-14: AFL3-W10A-AL RFID Reader Installation

Step 0:
Page 31