Mounting The System; Wall Mounting - IEI Technology AFL3-W10A-AL User Manual

AFL3-W10A/12A/W15A-AL Panel PC
Step 2: Update the BIOS and ME firmware, and then turn off the system power.
Step 3: Remove the metal clip on the Flash Descriptor Security Override jumper.
Step 4: Restart the system. The system will reboot 2 ~ 3 times to complete the ME
firmware

3.13 Mounting the System

The methods of mounting the AFL3-W10A/12A/W15A-AL are listed below.

Wall mounting


Panel mounting

Rack mounting

Arm mounting

Stand mounting

V-Stand mounting

The mounting methods are described below.
3.13.1 Wall Mounting
To mount the panel PC onto the wall, please follow the steps below.
Step 1: Select the location on the wall for the wall-mounting bracket.
Step 2: Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 3-21).
update.Step 0:
Page 37