Reinstalling The; Figure 3-4: Remove The Back Cover - IEI Technology AFL3-W10A-AL User Manual

AFL3-W10A/12A/W15A-AL Panel PC

Figure 3-4: Remove the Back Cover

3.4.1 Reinstalling the Back Cover
To install the back cover, slide the back cover toward the top cover until the external and
internal locking mechanisms are both clipped into place. Then, secure the back cover with
the previously removed screws. Please be aware of the type of screws when fastening the
back cover of the 12.1" and 15.6" models (refer to Figure 3-2 and Figure 3-3).
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
The following diagram shows the differences of the internal locking mechanism of the two
models.
Page 23