Unpacking - IEI Technology AFL3-W10A-AL User Manual

2.1 Unpacking

To unpack the panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the panel PC has been properly
installed. This ensures the screen is protected during the installation
process.
Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2: Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4: Lift the monitor out of the boxes.
Step 5: Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the panel PC.
Step 7:
Make sure all the components listed in the packing list are present.
Page 14
AFL3-W10A/12A/W15A-AL Panel PC
Step 0: