Figure 3-25: Afl-12A-Al Cutout Dimensions; Figure 3-26: Afl-W15A-Al Cutout Dimensions - IEI Technology AFL3-W10A-AL User Manual

AFL3-W10A/12A/W15A-AL Panel PC

Figure 3-25: AFL-12A-AL Cutout Dimensions

Figure 3-26: AFL-W15A-AL Cutout Dimensions

Step 1:
Slide the panel PC through the hole until the frame is flush against the panel.
Step 2:
Insert a M5*50 screw into the screw hole on the side of the panel mounting
bracket. Then, install the following components onto the screw in sequence.
See Figure 3-27.
Sequence
1
2
3
Item Photo
Spring
Nut
Plastic
cap
Instruction
Install a spring onto the screw.
Tighten a nut until the spring is
compressed enough for plastic cap.
Tighten a plastic cap onto the end of
screw thread.
Page 41