Rfid Reader Kit Installation (Optional); Figure 3-13: Rfid Reader Kit; K It I Nstallation (O Ptional ) - IEI Technology AFL3-W10A-AL User Manual

3.8 RFID Reader Kit Installation (Optional)

The optional RFID reader provided by IEI supports ISO15693, ISO14443A/B, Felica,
Mifare, Tag-it, ST LRI 1K and ST M24LRXX protocols.
To install the RFID reader kit, follow the steps below.

Figure 3-13: RFID Reader Kit

Step 1: Remove the plastic back cover. See Section 3.4 above.
Step 2: Connect the white connector of the RFID cable to the 4-pin connector on the
RFID reader module.
Step 3: Peel off the backing from the RFID reader module and stick the rubber foam on
it.
Step 4:
Refer to the following diagrams. Insert the antenna connector into the hole to
make the antenna cable go underneath the metal sheet and come out from
another hole where the RFID reader module will be installed. Tweezers is
needed to pull the antenna cable out of the hole.
Step 5: Connect the antenna cable to the antenna connector (U.FL) on the RFID reader
module.
Page 30
AFL3-W10A/12A/W15A-AL Panel PC