Hdd Installation; Figure 3-8: Hdd Bracket Retention Screws - IEI Technology AFL3-W10A-AL User Manual

3.6 HDD Installation

NOTE:
The HDD drive bay is only available in the 12.1" and 15.6" models. For
the 10.1" model, please install M.2 SSD as the storage device.
To install the HDD into the system, please follow the steps below:
Step 1: Remove the plastic back cover. See Section 3.4 above.
Step 2: Remove the four HDD bracket retention screws as shown below, and lift both
HDD brackets off the panel PC.

Figure 3-8: HDD Bracket Retention Screws

Step 3:
Attach the HDD brackets to the HDD. To do this, align the two retention screw
holes in the side of an HDD bracket with the retention screw holes on one side of
the HDD. Insert two retention screws into the HDD bracket to secure it. Follow
the same procedure to secure the other HDD bracket to the HDD (Figure 3-9).
Page 26
AFL3-W10A/12A/W15A-AL Panel PC