AFL3-W10A/12A/W15A-AL Panel PC
5.1 System Maintenance Introduction
If the components of the AFL3-W10A/12A/W15A-AL fail they must be replaced. Please
contact the system reseller or vendor to purchase the replacement parts. Back cover
removal instructions for the AFL3-W10A/12A/W15A-AL are described below.
5.2 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the maintenance of the
AFL3-W10A/12A/W15A-AL may result in permanent damage to the
AFL3-W10A/12A/W15A-AL and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the AFL3-W10A/12A/W15A-AL. Dry climates are especially susceptible to ESD.
It is therefore critical that whenever the AFL3-W10A/12A/W15A-AL is accessed internally,
or any other electrical component is handled, the following anti-static precautions are
strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding: - Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: - When configuring the AFL3-W10A/12A/W15A-AL,
place it on an anti-static pad. This reduces the possibility of ESD damaging
the AFL3-W10A/12A/W15A-AL.
Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.
Page 91