Configuring The Ip Addresses - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

ADAPTEC: Installation Complete
ADAPTEC: Please Reboot the system for the changes to take effect.
Note: The system lists an EMPCI address for each of
the ANA-6944A/TX ports.
8
Reboot the system.

Configuring the IP Addresses

1
To begin configuring the IP Addresses for the
ANA-6944A/TX, enter:
/etc/confnet.d/configure -i
The system lists the devices and displays the following message:
These are the devices available on your system:
1 EMPCI_0
2 EMPCI_1
3 EMPCI_2
4 EMPCI_3
Type the number of the device(s) to be configured with inet [?,??,quit]:
2
For the ANA-6944A/TX, enter the four addresses, using
spaces in between the numbers (no commas):
1 2 3 4
The system displays the following message:
Please enter the IP host name for device EMPCI_0 (default: xxx):
3
Enter the name of the host (string). The system displays the
following message:
Please initialize the IP address for the host xxx (default: xxx.xx.xx.xx):
4
Enter the IP address, or press Enter to use the default IP
address. The system displays the following message:
Configure host xxx with the default Ethernet (TM) if config options?:
(yes no ClassC BerkeleyC info; default:info):
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Installing Network Drivers
4-31
Page: 4-31
ECN Date: 5/97