Sco Unixware Smp; Installing The Drivers - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

PCI Ethernet and Fast Ethernet Adapters

SCO Unixware SMP

The ANA-6944A/TX, ANA-6901A, and the ANA-6911A/TX UNIX
drivers support SCO

Installing the Drivers

1
Insert the Unix Drivers diskette into the first floppy drive
(usually A).
2
Make a directory for the driver, as follows:
mkdir adaptec
3
Change to the directory you just created, as follows:
chdir adaptec
4
Copy the files from the floppy diskette to the hard disk, as
follows:
doscp a:\unixware\*.*.
5
Extract the files, as follows:
tar -xvf -d adaptec\empci.tar
6
To install the drivers, type:
./Install
The system loads the EMPCI modules and displays the following
messages:
ADAPTEC: Adaptec (10/100) PCI Fast Ethernet
Installation
ADAPTEC: Please Enter the Card you are Installing (1/2)
1. Adaptec ANA-6911A PCI EM110
2. Adaptec ANA-6944A PCI EM4400
7
Enter the number (1 or 2, as shown above) of the adapter you
are installing. The system displays the following messages:
ADAPTEC: Netinfo
EMPCI_0
EMPCI_1
EMPCI_2
EMPCI_3
ADAPTEC: Please use /etc/confnet.d/configure -i to configure the IP ad-
dress
4-30
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Page: 4-30
ECN Date: 5/97