Configuring The Drivers - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

PCI Ethernet and Fast Ethernet Adapters

Configuring the Drivers

17
From the Duralink Setup by Adaptec dialog box, choose the
appropriate connection type for your network. Use the default
selection, Autodetect Default Connection, if you don't know
the appropriate connection type. The options are:
Autodetect Default Connection
Detects the cable type and optimal line speed for the
specific Adaptec PCI adapter model in use. This is the
default and recommended connection type. refer to the NT
Help file in the Adapter Configuration dialog box for the
specific default settings for an adapter.
InitSense/Half Duplex
Detects the line speed (10 or 100 Mb/s) when the adapter
initializes and is set for Half Duplex mode.
InitSense/Full Duplex
Detects the line speed (10 or 100 Mb/s) when the adapter
initializes and is set for Full Duplex mode.
ActiveSense/Half Duplex
Detects the line speed (10 or 100 Mb/s) when the adapter
initializes and continues to check for change in the line
speed.The adapter is configured for Half Duplex mode.
ActiveSense/Full Duplex
Detects the line speed (10 or 100 Mb/s) when the adapter
initializes and checks for change in the line speed. The
adapter is configured for Full Duplex mode.
10 Mb/s UTP/Half Duplex
Forces the connection to 10 Mb/s in Half Duplex mode.
10 Mb/s UTP/Full Duplex
Forces the connection to 10 Mb/s in Full Duplex mode.
100 Mb/s/Half Duplex
Forces the connection to 100 Mb/s in Half Duplex mode.
4-16
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Page: 4-16
ECN Date: 5/97