Manual Installation - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

Manual Installation

For manual driver installation
1
Make sure that the system is clean.
Type load forcnfg to remove the adapters.
Load the INETCFG utility to delete all EMPCI boards.
Remove all load and bind commands related to EMPCI
from the sys:system\autoexec.ncf as well as the sys:etc\failover.ncf
line in the autoexec.ncf file.
2
Copy these files, empci.ldi, empci.lan, cdtdim.lan, failmib.lan
to the sys:system directory of the NetWare server from the
installation diskette to the sys:system directory of the NetWare
Server.
3
Edit the autoexec.ncf file manually, including the correct load
and bind commands. A sample set of load and bind commands
follows.
Load command for TCP/IP protocol (not needed if TCP/IP
is not used)
LOAD TCPIP
Load command for PRIMARY; B_INDEX indicates Backup
INDEX Number.
LOAD EMPCI NAME=PRIMARY_E82
FRAME=ETHERNET_802.2 INDEX=1 B_INDEX=2
Load command for BACKUP; P_INDEX indicates primary
INDEX Number.
LOAD EMPCI NAME=BACKUP_E82 FRAME=ETHERNET_802.2
INDEX=2 P_INDEX=1
Bind command for PRIMARY, there is no bind command
for BACKUP.
BIND IPX PRIMARY_E82 NET=101
Load command for DMI agent (except FAILOVER)
LOAD CDTDMI
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Installing Network Drivers
4-7
Page: 4-7
ECN Date: 5/97