Installing Os/2 Smp For The First Time - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

PCI Ethernet and Fast Ethernet Adapters
8
Under Protocols, highlight the desired network protocol(s) and
click Add.
9
Click Edit to change the ANA-6944A/TX configuration
settings, if desired.
If you selected IBM NetWare Requester Support from the
Protocols box, you need to make the following configuration
changes:
– In the Current Configuration box, highlight IBM NetWare
Requester and select Edit.
– Change the Token-Ring Support Option to NO.
– Enable one more of the listed Ethernet frame types by
specifying YES in the appropriate boxes. (If you are not
sure which frame type(s) are used on your NetWare
network, enable all of them).
– Change the Network Adapter Address to the Ethernet
address of your Adaptec adapter.
You can run emdiag.exe from your Adaptec driver diskette at
an OS/2 command line prompt, and choose Configuration
Status, to display your adapter's Ethernet address.
10
Make the changes and click OK.
11
In the Configure dialog box, select Close.
12
In the Multi-Protocol Transport Services dialog box, select Exit.
13
Select Update CONFIG.SYS and then select Exit.
14
Shut down OS/2 and reboot for your network driver and
protocol(s) to take effect.

Installing OS/2 SMP for the First Time

Follow these instructions if you are installing OS/2 SMP or
OS/2 Peer client for the first time.
1
Follow the general installation instructions provided with
OS/2 SMP to begin your installation.
2
During the installation, specify the type(s) of networks you are
using.
4-26
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Page: 4-26
ECN Date: 5/97