Remove Existing Adaptec Ethernet Drivers; Adding Standard Drivers - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

PCI Ethernet and Fast Ethernet Adapters

Remove Existing Adaptec Ethernet Drivers

6
Click the Adapters tab in the Network Setup dialog box.
7
To remove any currently installed Adaptec or Cogent PCI
adapters highlighting the adapter, click Remove, then click
OK. Repeat until all Adaptec or Cogent PCI adapter drivers
are removed.
8
Click Close to close the Network dialog box.
9
Click Yes to restart your computer.
Note:
When you restart Windows NT, a message may
indicate that at least one service failed to start. This message
will not appear after you add the new Duralink drivers in
the following steps. Click OK.

Adding Standard Drivers

10
Double-click the My Computer icon.
11
Double-click the Control Panel icon.
12
Double-click the Network icon.
13
Click the Adapters tab in the Network dialog box.
Note:
Do not allow Network setup to autodetect the
network adapter.
14
Click Add.
15
Click Have Disk.
16
At the prompt Insert disk with software provided by the
software or hardware manufacturer, insert the disk with the
Windows NT driver. Enter the path to the directory where the
driver and OEMSETUP file are located. Click OK.
17
Select the OEM Option dialog box. Select the adapter type (for
example, 6911, 6911A, 6944A, and so forth) or Adaptec PCI
Ethernet adapter. Click OK.
4-12
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Page: 4-12
ECN Date: 5/97