Table of Contents
Advertisement
Note:
If no drivers are currently installed for Adaptec or
Cogent PCI adapters, skip to step 13.
Remove Existing Adaptec Ethernet Drivers
6
Click the Adapters tab in the Network dialog box.
7
To remove any currently installed Adaptec or Cogent PCI
adapters highlighting the adapter, click Remove, then click on
OK. Repeat until all Adaptec or Cogent PCI adapter drivers
are removed.
8
Click Close to close the Network dialog box.
9
Click Yes to restart your computer.
Note:
When you restart Windows NT, a message may
indicate that at least one service failed to start. This message
will not appear after you add the new Duralink drivers in
the following steps. Click OK.
Adding Duralink Drivers
10
Double-click the My Computer icon.
11
Double-click the Control Panel icon.
12
Double-click the Network Setup icon.
13
Click the Adapters tab in the Network Setup dialog box.
Note:
Do not allow Network Setup to autodetect the
network adapter.
14
Click Add.
15
Click Have Disk.
16
At the prompt Insert disk with software provided by the
software or hardware manufacturer, insert the disk with the
Duralink failover driver. Enter the path to the directory where
the driver and OEMSETUP file are located. Click OK.
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Installing Network Drivers
4-15
Page: 4-15
ECN Date: 5/97
Advertisement
Table of Contents
