Installing The Drivers For A Pre-Existing Os/2 Smp - Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

The drivers are now displayed on the list of drivers.
4
Click Add to add the drivers.
Note:
If you added all four ports for the
ANA-6944A/TX, OS/2 automatically loads as many
drivers as you need when you reboot.
5
Select the appropriate protocols and click Add.
Note: If you need to configure each port with different
protocols, pay attention to the order of binding. The
first device on your list installs the driver for port 1
(the top connector on the card and the furthest from
the PCI bus connector). The second device loads port 2
(next to port 1), and so on.
6
Shutdown OS/2 and reboot for your network driver and
protocol(s) to take effect.

Installing the Drivers for a Pre-existing OS/2 SMP

Use the following instructions if you already have OS/2 SMP or
OS/2 Peer Client installed on your machine. If you are installing
OS/2 SMP for the first time, see Installing OS/2 SMP for the First Time
on page 4-26.
1
On your desktop, double-click the MPTS (Multi-Protocol
Transport Services) icon.
2
Select Install.
3
Select Install Additional Network Drivers, and specify
as the source. Select OK.
a:\ndis.os2
4
After the OS/2 driver is copied from the diskette, select OK.
5
Select Configure.
6
Select LAN Adapters and Protocols and then click Configure.
7
In the LAPS dialog box, under Network Adapters, highlight
the ANA-6944A/TX and click Add. Repeat this three times to
add the other three ports as separate devices.
PCI Ethernet and Fast Ethernet Adapters User's Guide
Stock Number: 511472-00, Rev. A
Print Spec Number: 496708-00
Current Date: 5/5/97
Installing Network Drivers
4-25
Page: 4-25
ECN Date: 5/97