Unpacking And Initial Setup; Installing The System In An Equipment Rack; Ambient Temperature - Adaptec RCM-FC2500 Manual

28

Unpacking and Initial Setup

Installing the System in an Equipment Rack

Ambient
Temperature
Unpacking and Initial Setup
When you receive your system, visually inspect the
exterior of the packaging for any signs of damage. If any
damage is found the carrier and Eurologic should be
informed immediately, and they will advise you of the
appropriate action. The cartons are sealed using packaging
tape which should be cut open in the normal manner.
Exercise caution when lifting out the components. At this
point the contents should be verified against the packing list
and Eurologic should again be notified if any discrepancies
exist. The disk drives are packaged in anti-static packaging
and anti-static precautions must be observed prior to
removal.
Before installing the SANbloc Series in an equipment
rack, it is essential that the following guidelines are
complied with, to ensure the safe and efficient operation of
the system. The SANbloc Series can be installed in open or
closed equipment racks, with a front width of 19", by
observing the environmental, electrical, and mechanical
precautions described below.
Installation of the rack system in a standard 19" cabinet
may lead to a differential between the room ambient temper-
ature and the internal ambient temperature of the rack
environment. The operating temperature of the SANbloc
o
Series is between 10 C to 40
mended that the system be continuously run at these extreme
o
C. However, it is not recom-