Biotek BioStack 4 Operator's Manual page 36

14 | Chapter 2: Installation
Upgrade Scenarios
If you purchased the BioStack to interface with an existing instrument, you may
need to upgrade the hardware and/or software on that instrument. Refer to the
table below and contact BioTek TAC with any questions.
Minimum computer control software for:
PC Software
LHC (Liquid Handling Control) 2.12 or higher
Gen5 (Data Analysis )
If you have:
ELx405
with Serial Number <=182187
with Serial Number
>=182188 and <185301
Eon
with Serial Number <1310151
Epoch
Any serial number.
Compatible instruments have a
"BioStack Ready" sticker:
models.
MicroFill‡
with Serial Number <185105
MicroFlo Select‡
with basecode version <1.06
PowerWave
with Serial Number <1310151
PowerWave HT is not compatible with BioStack4.
BioStack™ Microplate Stacker
BioStack 3
2.01 or higher
You may need:
A BioStack-compatible microplate carrier and new
basecode software (upgrade kit PN 7310006). The carrier
must be installed by authorized personnel.
New basecode software (upgrade kit PN 7310013).
Instruments with a lower serial number may not have a
BioStack-compatible plate carrier. Contact BioTek TAC.
A BioStack-compatible microplate carrier, which must be
installed by authorized Service personnel. Gen5 v.2.0 is
required.
R
New basecode software (upgrade kit PN 7310015).
New basecode software.
Instruments with a lower serial number may not have a
BioStack-compatible plate carrier. Contact BioTek TAC.
BioStack 4
2.16 or higher
2.05 or higher