To Report Scanned Codes With Precision/Xs - Biotek BioStack 4 Operator's Manual

104 | Appendix A: Install the Barcode Scanner
Use the drop-down list in the BioStack Selection field to identify the
l
BioStack and supply station.
De-select
l
Select
Ignore failures
l
9. Click
Generate List
scan each plate as it moves from the output stack to the input stack.
10. Note whether the following activities occur:
The red LED on the barcode scanner should flash as the scanner reads the
l
barcode on the plate at the extended carrier position.
Precision Power will look for an Available Plate Map with the same Plate
l
ID as the scanned plate. As it finds a match, it moves the plate map to the
Assigned Plate Maps, i.e., the To-Do List. All three barcode plate maps
should now appear in the Assigned Plate Maps list.
If a failure occurs during the process, Precision Power puts a placeholder in the
Assigned list marked with a red error icon. A barcode scanning error results in a
placeholder name
Remove the plate from the carrier, and check for a missing label, invalid
l
or illegible barcode, or a barcode label on the wrong side of the plate in
reference to the position of the scanner. Ensure that the barcode ID you
entered into Precision Power matches the barcode ID on the plate.
Correct the problem, place the plate back into the output stack, and home
l
the BioStack. Repeat steps 6 through 9.
If the test does not pass, contact BioTek TAC.
l

To Report Scanned Codes with Precision/XS

The BioStack is engaged by a Precision program through a Supply command.
BioStack-scanned barcodes are managed through the To-Do list.
Refer to
Setting Up a BioStack
BioStack to build the To-Do List
Topics > Plate Maps > To Do List).
BioStack™ Microplate Stacker
Limit by location count
.
to start the BioStack scanning process. The BioStack will
.
No barcode #
in the Precision Power User Guide and
in the Precision Power help system (Help > Help
.
To use the