Related Manuals for Biotek OM-1000
Summary of Contents for Biotek OM-1000
- Page 1 Dissolved Ozone Monitor Owner’s Manual www.biotek-ozone.com distributor OM-1000 Please read this manual carefully before starting operation.
- Page 2 Table of contents OM -1000 introduction Product Dissolved Ozone Monitor table of contents introduction Model No. OM-1000 installation Power Voltage 9V battery*1 external features Power consumption 25 mW LCD display button functions Concentration measurement range 0 - 6.0 ppm...
- Page 3 (cont.) OM-1000 health hazard data (cont.) Effects of Single Overexposure May cause irritation of the respiratory tract experi- enced as nasal discomfort, dryness, irritation of the...
- Page 4 LCD display LCD display technical information technical information material safety data sheet for ozone gas (cont.) fire and explosion hazard (cont.) Extinguishing Media Use extinguishing media appropriate for Temperature Mode the fuel source. Digit Display Special Fire Fighting Procedures Use self-contained breathing apparatus. Ozone is an oxidizer.
- Page 5 button functions technical information To turn the power on and off. After turn on the system, it will automatically turn off every 10 minutes. For choosing the appropriate mode: Press the SET button one time on the common mode into the appropriate mode. Press the SET button a second time to return to the common mode.
- Page 6 Common test mode When the ozone concentration in water is suspected to lie between 0 to 2 ppm, the test steps are as follows: (If the actual concentration is higher than 2 ppm, the monitor will indicate this by showing “EPP” on the display. If “EPP” is shown for at least 3 seconds, follow the measurement steps described on page 6) Prepare a clean beaker that can hold at least 1000 ml with a diameter of about 8 cm.
- Page 7 operation instructions operation instructions When the ozone concentration in water is suspected to be more than 2 ppm, the test steps are as follows: Prepare a clean beaker of at least 1000 ml with a diameter of about 8 cm and put 200 ml tap water inside.
- Page 8 Memory test mode When the ozone concentration in water is suspected to be more than 2 ppm, or when “EPP” is shown on the display for at least 3 seconds, the test steps are as follows: When the ozone concentration in water is suspected to lie between 0 to 2 ppm, the test steps are as follows: (If the actual concentration is higher than 2 ppm, the monitor Prepare a clean 300 ml beaker with a diameter of about 8 cm and put 100 ml tap water will indicate this by showing “EPP”...
Need help?
Do you have a question about the OM-1000 and is the answer not in the manual?
Questions and answers