U: Monitors - YASKAWA CIMR-JA Series Installation & Start-Up Manual

B.2 Parameter Table
No. Name
IGBT
Sets the value of the IGBT Maintenance monitor
o4-09 Maintenance
U4-07.
Setting
Selects if U2-oo (Fault Trace) monitors are reset at
o4-11 U2 Initialize drive initialization.
Selection 0: Saves the fault monitor data
1: Resets the fault monitor data
<12> Default setting value is dependent on parameter o2-04, Drive Model Selection.
<22> Parameter can be changed during run.
<61> Valid for drive software 1011 and later. Value is set in 1 h units for older software.
u

U: Monitors

Monitor parameters allow the user to view drive status, fault information, and other
information about drive operation.
No. Name
U1-01 Frequency
Monitors the frequency
Reference
U1-02 Output Displays the output frequency. Display units are
Frequency determined by o1-03.
U1-03 Output
Displays the output current.
Current
Output
U1-06 Voltage Displays the output voltage.
Reference
U1-07 DC Bus
Displays the DC bus voltage.
Voltage
Displays the input terminal status.
U1-10 Input Terminal
Status
216 YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
Description
Description
U1: Operation Status Monitors
Use U1 monitors to display the operation status of the drive.
Digital input terminal
S1 enabled
Digital input terminal
S2 enabled
Digital input terminal
S3 enabled
Digital input terminal
S4 enabled
Digital input terminal
S5 enabled
Mode Addr.
Range Def.
V/f
0 to 150 0% O
0, 1 0 O
Analog
Output Level Unit
10 V: Max 0.01
frequency Hz
10 V: Max 0.01
frequency Hz
10 V: Drive 0.01
rated current A
10 V: 200 Vrms
0.1 V
(400 Vrms)
10 V: 400 V (800
1 V
V)
No output signal
–
available
Pg.
Hex
525 —
510 —
Mode Addr.
Hex
V/f
O 40
O 41
O 42
O 45
O 46
O 49