YASKAWA CIMR-JA Series Installation & Start-Up Manual page 81

Frequency reference
display at power up
STOP
Press until the frequency
reference becomes 6 Hz
Figure 4.4 Setting the Frequency Reference while in Drive Mode
Note: The drive will not accept a frequency reference set value unless the ENTER key is pressed after the frequency
reference is entered. This feature prevents accidental setting of the frequency reference. By setting o2-05
(Frequency Reference Setting Method Selection) to 1 (Enabled), the drive will accept the frequency
reference while it is being adjusted on the digital operator.
n Programming Mode Details
The following actions are possible in the programming mode:
• Verify Function: Verify parameter setting changes from original default values.
• Setup Group: Access a list of commonly used parameters to simplify setup.
• Parameter Setting Mode: Access and edit all parameter settings.
The Setup Group within the Programming Mode
In Setup Group, the user can access the minimum group of parameters required to operate the
application.
Note: Setup Group parameters are listed in
Figure 4.5 illustrates the keys to press to enter the Setup Group.
In this example, the source of the frequency reference is changed from the control circuit
terminals to the LED Operator (i.e., b1-01 is changed from 1 to 0).
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
Press to select LOCAL
Table 4.4.
4.3 The Drive and Programming Modes
Press to select the
digit to the right
4
81