Safety Instructions And General Warning; High Voltage - Danfoss VLT Automation Drive FC 300 Operating Instructions Manual

®
VLT Automation Drive FC 300
Operating Instructions High Power

2. Safety Instructions and General Warning

Caution
The frequency converter DC link capacitors remain charged after power has been disconnected. To avoid electrical shock hazard, disconnect the
frequency converter from the mains before carrying out maintenance. Before doing service on the frequency converter wait at least the amount of
time indicated below:
380 - 500 V
525 - 690 V
These Operating Instructions can be used for all FC 300 frequency converters with software version 4.8x.
The software version number can be seen from parameter 15-43.

2.1.1. High Voltage

The voltage of the frequency converter is dangerous whenever the frequency converter is connected to mains. Incorrect installation
or operation of the motor or frequency converter may cause damage to the equipment, serious personal injury or death. The instructions
in this manual must consequently be observed, as well as applicable local and national rules and safety regulations.
Installation in high altitudes
380 - 500 V: At altitudes above 3 km, please contact Danfoss Drives regarding PELV.
525 - 690 V: At altitudes above 2 km, please contact Danfoss Drives regarding PELV.
Equipment containing electrical components may not be disposed of together with domestic
waste.
It must be separately collected with electrical and electronic waste according to local and currently
valid legislation.
90 - 200 kW
250 - 800 kW
37 - 315 kW
355 - 1000 kW
FC 300
Operating Instructions
Software version: 4.8x
MG.33.U2.02 - VLT ® is a registered Danfoss trademark
2. Safety Instructions and General Warning
20 minutes
40 minutes
20 minutes
30 minutes
2
7