Danfoss VLT Automation Drive FC 300 Operating Instructions Manual page 41

®
VLT Automation Drive FC 300
Operating Instructions High Power
Required Tools:
• Socket wrench with 7-17 mm sockets
• T30 Torx Driver
Torques:
• M6 - 4.0 Nm (35 in-lbs)
• M8 - 9.8 Nm (85 in-lbs)
• M10 - 19.6 Nm (170 in-lbs)
Kit Contents:
• Pedestal parts
• Instruction manual
Install the pedestal on the floor. Fixing holes are to be drilled according
to this figure:
Mount the drive on the pedestal and fix it with the included bolts to the
pedestal as shown on the illustration.
Illustration 3.29: Mounting of drive to pedestal.
Illustration 3.30: Drill master for fixing holes in floor.
Illustration 3.31: Mounting of drive to pedestal
MG.33.U2.02 - VLT ® is a registered Danfoss trademark
3. How to Install
3
41